Square and Shape Epoxy Components

to the other surface as possible after being done with the Joiner we brought it to the table saw and started squaring off off the edges not much usually about a quarter to even less than that was taken off on each side to create these nice beautiful almost Ice Cube looking Dimensions once we get of our pieces flat we're going to bring our smart technology we're going to lay our phone on our watch and make a marking where the watch will begin with the arm and then where it will meet the phone once we make a little markings use a little square to trace out exactly where the cut will take place now before we cut we're going to bring it to the table saw we're going to tilt the blade about 15° and we're going to create one swift cut on the bottom this is the part that's going to sit towards the base and get glued after creating a nice safe miter cut we can bring it over to our band saw and cut out the arm that we laid out earlier with the smart technology if you don't have a band saw you can always use a jigsaw and just take your time with it