Route Channels and Drill Holes for Cables

I ratted a channnel at the bottom of the base plate to anticipate Ever Getting either a larger phone or a larger case to do so you can take a bull-nose router with your palm router secure a straight edge and take small incremental passes to get to about a/4 in depth now to conceal some of these cables we'll need to drill a few holes the first one will be 1 and 1/8 in in diameter forer bit that will secure the charging station then we'll take a/2 in forcer bit and drill hole all the way through this is where the cable will go towards the back now we need to create a channel that will go from one hole to the other to do so let's lay down some tape to prevent scratching and then use any kind of small bladed saw like in my situation this Dremel saw and create a channel that will run about about a 1/8 in in width from one hole to the other remove the tape and then do the same thing but on the bottom of the docking station this is going to be the part where the charger from the phone is going to have the cable run all the way down through a hole and then run down a channel to be concealed as well attaching the top and