Skip to main content
Stesso

Apply Pressure to Resin

6:15
11:11
10K views

At 6:15 in

How to repair a cracked/chipped windshield under $15..Farm stuff, GUNFIRE! and A RANT!!

Watch on YouTube

What happens here

After 10 minutes in the vacuum position, release the syringe plunger and allow a small amount of air into the system. Then, press the plunger all the way down until it locks into the second notch. This action applies pressure, further forcing the resin into any remaining voids within the chip. Leave the syringe in this pressure position for an additional 20 minutes. Ensure the seals remain intact throughout this process to maintain effective pressure.

Goal: Force resin deeper into the crack to fill remaining voids.

What they say

Hide

minutes so supposed to save this for the final step so after 10 minutes you release your clip so you take this out then you let a little air in there that's what it says then there's another notch right here you open it up you depress back in there and then you squeeze down to lock some pressure on the other notch and right there's the other notches a notch here and there's a notch here and this one is for pulling up and that one's for pulling down leave this in position for 20 minutes the other way it was for 10 minutes make sure we got a good seal so while we're

Auto-generated from the video audio.