Skip to main content
Stesso

Rear Fender and Lighting Customization

1:44
8:00
623 views

At 1:44 in

HARLEY SPORTSTER BIKE BUILD | MOTO VLOG 1

Watch on YouTube

What happens here

To achieve a 'chopped' look for the rear, the fender supports that originally extended further back were cut using an angle grinder. An aftermarket fender, purchased from Amazon, was then bolted in place. Integrated smoked tail lights, which also function as turn signals, were installed on both sides of the rear. A license plate bracket, incorporating a brake light, was also added.

Goal: Achieve a chopped rear fender look with integrated lighting and license plate.

Tools and materials

  • Aftermarket Rear Fender — Replacing the original fender for a custom look
  • Angle Grinder — Cutting the rear fender supports
  • License Plate Bracket with Brake Light — Mounting the license plate and providing additional brake lighting
  • Smoked Tail Lights/Blinkers — Providing rear lighting and turn signals with a custom aesthetic

What they say

Hide

all right so we have the chopped rear fender here i went and i chopped these off they used to extend out to about here the fender supports chop them off just with an angle grinder bought the fender off of amazon bolted it through here along with the rear tail lights smoked rear tail lights that i have on both sides the wiring is up in there got this license plate bracket with the third brake light not with the brake light not the third brake light i'm used to jeeps with the brake light back here

Auto-generated from the video audio.