Prepare Disposal for Connections

time. Make sure that didn't move. Grab our screwdriver and start tightening. I just like to rotate around. tighten them all evenly until it's completely tightened up. If you come up to the top, you're going to see the plumbers's putty ooze out. You're able to peel that off and then take a screwdriver, go around the skinny edge, get all that out, good to go. If you're running your dishwasher drain like this through your garbage disposal, you're going to want to pop this piece right here out. Not really seen this new style finangled thing yet, but I'm excited about that. Guess I haven't installed a garbage disposal in a long time. I've been on septic for so long. You just take your garbage disposal tool that comes with it. Pop that there. Pops right out. Now we can just hook right up to this. Next thing we'll do is grab our new cord. You got to remove this screw and it take this and it really just slides in as far as I can tell. Tighten this back down. Doesn't get easier than that, man. If you don't know, down here on the bottom is if your Incinerator garbage disposal gets jammed, you can stick this tool right here in it. Not only does this tool help you take the disposal off and put the disposal on, but it also helps you if you've got a jam. Is there no more reset button, though? After reading the instruction manual, it says that now you're supposed to shut it off and let it cool down for 20 minutes, then do it, and it should be good. There's no more manual reset. Wild. Just take this,