Skip to main content
Stesso

Fabricate Custom Hand Grip

1:01
6:26
75.8K views

At 1:01 in

DIY Under Desk Printer Stand

Watch on YouTube

What happens here

Design and cut the custom hand grip into the top panel of the cabinet. Start by marking the shape and size of the grip based on personal preference. Use a band saw for the main straight cuts of the grip, then drill a pilot hole with a 1/2-inch drill bit before feeding a jigsaw blade to cut the internal curves and remaining sections. Smooth out any saw marks with a hand rasp and finish by routing the edges of the hand grip with a 3/8-inch round over bit for comfort and a finished look.

Goal: Create a smooth, comfortable hand grip on the top cabinet panel for easy pulling.

Tools and materials

  • 1/2" Drill Bit — Creating the pilot hole
  • Band Saw — Making initial straight cuts for the hand grip
  • Cordless Drill DeWalt — Drilling a pilot hole for the jigsaw blade
  • Hand Rasp — Smoothing out rough saw marks
  • Jigsaw Ryobi — Cutting the internal curves and detailed sections of the hand grip
  • Pencil — Marking cut lines and layout
  • Printer HP Envy Photo 7155 — Used as a reference for sizing the cabinet and hand grip
  • Router with 3/8" Round Over Bit Ryobi — Rounding the edges of the hand grip for a smooth finish
  • Speed Square / Combination Square — Ensuring square layout and precise markings

What they say

Hide

deep now as far as the unique design of this cabinet I wanted to sit underneath my floating desk in the office be able to print it at any time I want but when it comes to using the top scanning part the cabinet would need to be pulled out so I wanted to create a custom hand grip for it to be able to push and pull the cabinet out of place and into place once I got all my notches figured out I came over to my band on to create the cut now I use my bansel mostly because I wanted to create a straight of a cut that I could that perhaps a jigsaw might not mostly because I was going to edgeband this area for the inner part of the grip I created a pilot hole with a/2 in drill bit fed my jigsaw blade in and cut the inner parts of the hand grip out once I was done cutting it out I noticed there's a few saw marks left over so I clean them up using a handheld rasp and then went over all the edges with the 38 round over bit with my router for the

Auto-generated from the video audio.