Skip to main content
Stesso

Clean and Secure Fasteners on OSB Walls

0:13
0:37
22.3K views

At 0:13 in

Day 1 of renovating my garage

Watch on YouTube

What happens here

Begin by thoroughly cleaning the entire OSB surface. Use a broom, a stiff brush, or a shop vacuum to remove any dust, cobwebs, dirt, or loose particles from the walls. A clean surface is essential for proper adhesion of joint compound and primer. After cleaning, carefully inspect all nails and staples on the OSB surface. Use a hammer to pound in any protruding nails until they are flush with or slightly countersunk into the surface. For staples, either firmly pound them down if they are slightly raised or carefully pull them out using a pry bar or pliers if they are loose or damaged. Ensure no fasteners are left sticking out.

Goal: Remove debris and ensure all fasteners are flush or removed for a smooth base.

Tools and materials

  • Broom — Removing dust and loose debris from the walls
  • Hammer — Pounding in nails and staples
  • Pliers — Pulling out staples or small nails
  • Pry Bar — Removing stubborn staples or nails
  • Shop Vacuum — Thoroughly cleaning the wall surface, especially textured areas

What they say

Hide

Most people paint OSB like drywall and it turns out like trash. Rough texture, gaps, nail holes, and it soaks up paint unevenly. Just painting it won't fix this. If you don't prep this wall, it's actually going to make this worse. You need to clean it really well, pound in all your nails and your staples or pull them out, then go ahead and seal your seams, sand it down, and then prime and top coat. I'm going to be taking this wall from this to

Auto-generated from the video audio.