Skip to main content

Cut Right Piece for Inside Corner

0:40
1:41
125.7K views

At 0:40 in

Cutting crown molding flat

What happens here

For the right piece of an inside corner, place the crown molding flat on the miter saw's bed, with the right end of the molding on the right side of the saw. Set the miter angle of the saw to 31.6 degrees to the left of center. Then, tilt the saw's blade (bevel) to the right at 33.9 degrees. Ensure the 'ceiling side' of the crown molding is firmly against the saw's fence. Make the cut.

Goal: Cut the right piece of crown molding for a precise inside corner joint.

Tools and materials

  • Crown Molding — The material being cut
  • Miter Saw RIDGID — Cutting the crown molding at precise angles

What they say

Hide

put it at 31.6. Tilt your bevel left set to 33.9. Ceiling side towards your fence and cut. Take your right piece, put it on the right side of your saw, move your miter to the left. Move your bevel to the right. Should look like that. Put them where you want them and nail. Left. Right. For an outside corner, saw goes

Auto-generated from the video audio.