Verify Power at Water Heater Unit

0:48

1:00

23.3K views

At 0:48 in

Customer had a Bad Water Heater, what would you do if you were at this job? #electrician

Watch on YouTube

What happens here

Proceed to the water heater unit itself. The video briefly shows the electrician using a non-contact voltage tester to confirm that power is indeed reaching the water heater's terminal connections. This step is critical to differentiate between a problem at the electrical panel (like a faulty breaker or wiring) and a problem within the water heater unit (like a bad element or thermostat). A non-contact tester will light up or beep if voltage is present.

Goal: Confirm that electrical power is successfully reaching the water heater's internal components.

Tools and materials

Non-contact voltage tester — Detecting the presence of AC voltage at the water heater terminals

What they say

(433 characters)

Hide

breaker and try to flip it on I then put my clamp meter on to measure amperage and was drawing around 1.8 amps so then I went inside the building to the water heater and check the power so the water heater seemed to be working fine and I called the customer to let him know if the breaker Trips Again he might just need a new circuit breaker let me know what you guys think in the comments but we came out and gave a proper diagnosis

Auto-generated from the video audio.