Skip to main content
Stesso

Introduction and Tool Preparation

0:02
11:06
65.2K views

At 0:02 in

Cleaning A Graco Contractor II Gun. Repair an Airless Spray Gun.

Watch on YouTube

What happens here

Chris the Idaho Painter introduces the video's goal: to demonstrate how to disassemble, clean, and reassemble a Graco Contractor II spray gun, specifically focusing on the packings. He then details all the required tools and materials. These include a 5/8 inch wrench for loosening/tightening components, an old toothbrush for scrubbing, Q-tips for cleaning hard-to-reach internal areas, lacquer thinner (placed in a cup for soaking), a very small flathead screwdriver (like one used for eyeglasses) to carefully remove O-rings, WD-40 for lubricating parts during reassembly, and O-ring lube to apply to the O-rings for smooth installation and sealing. He also mentions using ProGold Pro Towels for hand cleaning.

Goal: Understand the project's scope and gather all required tools and materials for spray gun maintenance.

Tools and materials

  • 5/8 inch wrench — Loosening and tightening threaded sections of the gun
  • Cup for thinner — Holding lacquer thinner for soaking gun parts
  • Graco Contractor II Gun Graco — The primary tool being disassembled and maintained
  • O-ring lube — Lubricating O-rings to prevent damage during installation and ensure a tight seal
  • Old toothbrush — Scrubbing paint residue and grime from gun components
  • Q-tips — Cleaning small, intricate internal areas of the gun
  • Small flathead screwdriver — Carefully removing O-rings without causing damage
  • WD-40 WD-40 — Lubricating gun mechanisms during reassembly and preventing future paint buildup
  • Lacquer thinner — Dissolving and cleaning paint from gun components
  • ProGold Pro Towels ProGold — Cleaning hands and wiping down gun parts

What they say

Hide

Chris the Idaho Painter. In this video, we're going to show you how we take a Graco Contractor 2 gun, disassemble it, take the packings out, clean it, and put it back together. And in this task, you're just going to need a couple items. You're going to need a 5/8 inch wrench. I use a just an old toothbrush to do the cleaning. I use just Q-tips to get inside and clean the inside of the gun. Also got some lacquer thinner that I actually put into a cup to actually clean my parts with. And then I've got a very small tiny flathead screwdriver like for a pair of eyeglasses that I actually use to remove the O-rings. And then I've got some WD40 that when I'm putting the gun back together, I like to lube the gun. And I also actually have some O-ring lube that I like to put back on the O-rings when I put the gun back

Auto-generated from the video audio.