Stain Vanity & Build Drawers/Doors

these okay so I don't know if you notice anything different about this vanity since the last scene but it's completely different it's a completely different vanity and I'm an idiot and let me explain why this right here is the vanity that you've been seeing me build and I'm such an idiot that yesterday I went to the cabin to go check up on some things and I looked at my measurements and I was off by 10 in I built this thing 10 in too big I looked at the tape measure from the wall and saw 54 turns out I was looking at it upside down and it's 45 so that's what I get I get to make another vanny the cool thing is I'm going to reuse that for another project but I rebuilt this one made these openings equally the same size this is still the same the back is a little bit different I still put a backer piece in the back so you don't see the plumbing but I continue these shelves out I'll drill through these holes and puncture the water lines from the ground coming up so you won't see them and uh that's pretty much the only difference so now that's done let me build the drawers holy smokes did you guys get that on video look at this thing just fling right at me hit me right here avoided the uh you know Old Faithful down below jeez I'm glad I had my ppes and all that sunk safety glasses all that stuff up it could have gone worse 100% my fault this stuff is flimsy it bends right most of the time it already comes a little warped whatever it's quarter inch what do you expect from it so you have to keep consistent downward pressure not letting go at all and I didn't do that but number one thing that could have prevented this 1,000% is if I had my damn ring knife on my saw I always have it on but then I took it off because I was using my Crosscut sled earlier and man lesson learned keep your ring knife on kids and keep good pressure woo okay we're back in business nothing got chopped off you a/ Quin plywood but speaking of quinch plywood that's our bottom of our drawer half inch Maple for the drawers I have to edgeband them of course nobody likes those plywood and neither should you that's just lunacy s them together glue them all up let them dry install it [Music] you know what we're going to start doing we're going to start doing some doors and some drawer faces uh I got my select Pine here fortunately there's not a whole lot to do here one door four drawer faces I love using my router for this kind of stuff just because how Flawless and repeatable things are we got our…