Skip to main content

Remove Front Driveshaft and Exhaust Crossover Pipe

8:34
51:02
54.8K views

At 8:34 in

Budget Turbo Yukon XL 4L80 Conversion (Part 1): Blow'd Up 4L60e Removal! + Tips&Tricks To Save Time!

What happens here

Proceed to the front driveshaft. Unbolt it using an impact wrench. Next, using the same impact wrench, remove the bolts securing the exhaust crossover pipe. This pipe is usually located near the transmission and may obstruct access to other components. Carefully detach and remove both the front driveshaft and the exhaust crossover pipe.

Goal: Detach and remove the front driveshaft and exhaust crossover pipe

Tools and materials

  • Heat Gun

What they say

Hide

it could be yours okay now the front drive shaft oh it's leaking cool i need to find a receptacle for the leak okay that's her job grabbing containers and other nonsense no my clean floor i'm trying to take the crossover off anyway to get to that and this nice tile wastegate shining like a diamond in a goat's ass under here but they're going to be the same uh 11 millimeter or 7 16 i believe it's the crossover for that same thing hopefully these ones are easier to get out because all the salt flies backwards so naturally the back is the worst spot well you know what i always say you're not working till you're bleeding guess i'm working now courtesy of this here skid plate and uh old ratchet wrench she's uh working on preparing the tools to get the crossover off we're gonna have to do that and i kind of screwed ourselves because we're gonna have to take the down pipe off i don't have to move that lower everything back down what was that just like take like a wire girl cleaner you like rub it on the rusty sh you know like cleans all the charge off the grill i feel like you could do that under here the whole truck would be gone it's not all rest can't raise a pile of dirt but it doesn't like you could just do that you know you're probably right maybe we'll get some brushes and you can do that tomorrow you're an official employee now it could be your job uncle rob russ removal is it the wrong way check it make sure you're not loosening it or that you're not tightening it just spin it put the trigger and spin it yeah you're tightening it but yeah well don't put it in there what that should be tightening it cause this is the forward one right just look at the way the socket spins oops well you lost it cool nice all right two more oh thanks that's what i always always wanted one of those uh you like nuts you like nuts keep going there you go we're gonna have to get up on a ladder and get that downpipe

Auto-generated from the video audio.