Skip to main content
Stesso

Prepare and Paint the Wooden Base

9:43
13:15
16.6K views

At 9:43 in

BEST TOOL For Painting Cabinets! LED Inspection Light.

Watch on YouTube

What happens here

To create a stable and aesthetically pleasing base for the LED light bar, the presenter uses a piece of 1x4x6 pre-primed wood. He first measures the LED light bar to determine the appropriate length for the wooden base, marking about an inch to 1.5 inches of overhang on each side. He then uses a Milwaukee chop saw to cut the 1x4x6 pre-primed wood to the marked length. Next, to give the wooden base a finished and professional look, he uses a Makita router to round one of the long edges. Finally, the cut and routed wooden piece is painted white using white paint and a paintbrush, which will provide a clean, reflective surface and protect the wood.

Goal: Create a finished, stable, and painted wooden base for the light bar.

Tools and materials

  • Makita Router Makita — Routing a rounded edge on the wooden base for aesthetics and safety
  • Measuring Tape — Measuring the length of the light bar and marking the wood
  • Milwaukee Chop Saw Milwaukee — Cutting the wood to the desired length
  • Paintbrush — Applying paint to the wooden base
  • Pencil/Marker — Marking the cut line on the wood
  • 1x4x6 Pre-Primed Wood — The stable base for mounting the light bar
  • White Paint — Painting the wooden base for a clean, professional finish

What they say

Hide

our piece of wood that we're going to mount it on so what i want to do is this i'm going to only have about yo about about an in let's see we'll call it about inch and a half two inches i'll measure that make a mark or i'm going to cut that we're going to cut that right we'll make a mark where we're going to cut the board right here so we just have about an inch or so left over i'm going to cut that the saw you can just use a hand saw i'm just going to use a chop saw it does kind of have a round routed edge so i'm going to route that edge too because i want that to look nice and clean and then we will take and paint this and then we'll attach it to our piece of wood and our light bar will be good and ready

Auto-generated from the video audio.