Skip to main content

Install Lid Hinges and Supports — Attach Lid (Optional)

Beginner4 hours

Part of project

How to Build a Simple Wooden Box Step · Step 5 of 6

Helpful?

In this video

Attach the lid to the box using T-hinges. Position the hinges on the back edge of the lid and the corresponding 2x4 support on the box. The builder initially faced an issue where the lid didn't fully cover the 2x4 at the back, so a small strip of wood was glued and screwed into place to provide a mounting surface for the hinges. Secure the hinges with screws, ensuring they go through the hinge, the added wood strip, and into the underlying 2x4. Due to the heavy lid, install four hinges for sufficient support and distribute the weight evenly. The builder initially attempted soft-closing hinges, but they proved too weak for the lid's weight and were replaced with basic lid supports that hold the lid in an open position.

704.1K views19.7K
Make Something

944K subscribers

View Channel

FAQs

Which tools are absolutely essential for a beginner, and are multiple hammers necessary for this project?

For a simple box, a measuring tape, pencil, miter saw (or hand saw with miter box), square, sandpaper, and a single hammer are essential. The specialized drywall hammer and hinge bit are useful if you're installing a hinged lid, but not strictly required for the basic box structure itself.

Why is pine wood recommended for this project, and can I use other types of wood?

Pine is a great choice for beginners due to its affordability, widespread availability, and ease of cutting and sanding. You can certainly use other woods like poplar or plywood for different aesthetics or increased durability; just be aware they might be harder to work with or more expensive.

What are the most important safety precautions I should take when cutting and assembling the box?

Always wear eye and ear protection when using a miter saw or other power tools. Ensure your workpiece is securely clamped before making cuts, and keep hands clear of the blade. When assembling, be mindful of hammer swings and pre-drill pilot holes to prevent wood splitting.

What are common mistakes beginners make building a wooden box, and how can I avoid them?

Common mistakes include inaccurate measurements leading to uneven cuts, and rushing assembly resulting in a crooked box. Always 'measure twice, cut once,' use a speed square to mark precise lines, and dry-fit your pieces before final assembly to check for fit.

Transcript
Hide

Figuring out where to put the hinges were one of the more challenging thing for me on this project I ultimately set up for this because I got tired of overthinking it The lid didn't cover the entire two by four near the back Initially I had a different top for this when I drew it up But being it I changed it, I ended up figuring this out as I went I added a small strip of wood so I had somewhere to mount the hinge Then I used a long screw to go through the hinge to strip of wood and into the board And finally I secured a hinge to the two by four beneath With the weight of the lid, I rather overdue this than to underdo it So I spaced the hinges out enough so I can add four Whenever the wood is completely dried out and I have to give it time, I likely just paint the entire thing To install the soft closing hinge I needed a bit more surface So I added a piece of wood here glued it and screwed it I installed the soft closing hardware on both sides and attached it to the lid This ultimately became a failure because it wasn't strong enough to hold the lid I suspected that but I wanted to give it a try anyways Now I have to find a different type of solution because the lid is just too heavy In the meantime I swapped those out for this type of lid support While they are basic they get the job done it locks the lid in the open position

Auto-generated transcript. May contain errors.