Install Springs and Counterbalance System — Connect the Torsion Spring to the Door

Beginner6 hours

Part of project

Garage Door Opener Installation · Step 4 of 11

Helpful?

In this video

The torsion springs are carefully assembled onto the shaft. Once assembled, the entire spring and shaft unit is lifted and mounted securely to the framing above the garage door. The installation crew notes that the pressure-treated material added during the framing step made this process significantly easier, as it provided a solid base without requiring extensive use of concrete anchors. After mounting the springs, the counterbalance lift cables are attached: one end to a bracket at the bottom of the door and the other to the drums on the spring shaft.

159.5K views6.6K

Transcript

Hide

shaft in place next I assembled the Springs onto the shaft and mounted that whole assembly to the wall and all of that pressure treated material they added earlier made that installation process a lot easier so they didn't have to use a whole bunch of concrete anchors once the shaft and springs were in place they could attach the counterbalance lift cables to a bracket at the bottom of the door and the drums at the top of the door and this mechanism allows this very heavy door to be lifted by hand in case of power failure and also helps to reduce the load on the motor next I could tension the torsion springs

Auto-generated transcript. May contain errors.

Install Springs and Counterbalance System — Connect the Torsion Spring to the Door

Advanced

6 hours

Part of project

Garage Door Opener Installation · Step 4 of 11

Was this clip helpful?

In this video

The torsion springs are carefully assembled onto the shaft. Once assembled, the entire spring and shaft unit is lifted and mounted securely to the framing above the garage door. The installation crew notes that the pressure-treated material added during the framing step made this process significantly easier, as it provided a solid base without requiring extensive use of concrete anchors. After mounting the springs, the counterbalance lift cables are attached: one end to a bracket at the bottom of the door and the other to the drums on the spring shaft.

159.5K views6.6K

Video Transcript

(615 characters)

Hide

shaft in place next I assembled the Springs onto the shaft and mounted that whole assembly to the wall and all of that pressure treated material they added earlier made that installation process a lot easier so they didn't have to use a whole bunch of concrete anchors once the shaft and springs were in place they could attach the counterbalance lift cables to a bracket at the bottom of the door and the drums at the top of the door and this mechanism allows this very heavy door to be lifted by hand in case of power failure and also helps to reduce the load on the motor next I could tension the torsion springs

Transcript may be auto-generated and contain errors.