Squeaky Door Hinge Repair

Gently open and close the door several times, paying close attention to the sound it makes. Try to isolate the noise to a specific hinge. If multiple hinges seem to be squeaking, address them one at a time.

Open the door wide enough to access the hinge. If possible, slightly lift the hinge pin by tapping upwards on the bottom of the pin with a hammer and a nail set or screwdriver. Apply a few drops of lubricant, such as WD-40, silicone spray, or a graphite-based lubricant, directly onto the hinge pin and into the seams where the hinge leaves meet. Work the lubricant in by opening and closing the door several times.

Open and close the door slowly and quietly. Listen to determine if the squeaking noise has stopped. If the squeak is gone, proceed to clean up any excess lubricant.

Using a clean rag, wipe away any lubricant that may have dripped onto the hinge, door, or frame. This will prevent dust and dirt from accumulating on the lubricated surfaces.

If the squeak is still present after initial lubrication, you may need to remove the hinge pin completely. With the door slightly ajar, use a hammer and nail set or screwdriver to tap the pin upwards from the bottom until it can be pulled out. Clean the pin thoroughly with a degreaser or steel wool to remove any rust or grime. Lubricate the pin and the inside of the hinge barrels generously, then reinsert the pin and test the door again.

If, after all attempts at lubrication and cleaning, the hinge continues to squeak, it may be worn out or damaged. In this case, the most effective solution is to replace the entire hinge. You will need to purchase a new hinge of the same size and type, remove the old one by unscrewing it from the door and frame, and install the new hinge.