Apply plumber's tape (Teflon tape) to the threads of the shower arm and new components in a clockwise direction. Screw on the new showerhead and handles by hand, then use an adjustable wrench to further tighten them gently. Avoid over-tightening to prevent damage.
Step 1
⏱ 2 min
Turn Off the Water Supply
Before starting, safety first! Turn off the water supply to your shower. Locate the shut-off valves near the shower or at your main water supply panel. Turn the valves clockwise to completely stop the water flow. Double-check that the water is off before proceeding.
Step 2
⏱ 2 min
Remove the Old Shower Hardware
Carefully remove the old showerhead and handles. Use an adjustable wrench if needed, protecting the finish with a cloth or rag to avoid scratches. Turn the showerhead and handles counterclockwise to loosen and remove them.
Step 3
⏱ 2 minInstall New Shower Hardware
Step 4
⏱ 2 min
Test for Leaks
Turn the water supply back on and carefully inspect all connections for leaks. If any leaks are detected, immediately turn off the water, tighten the connections, or reapply plumber's tape as needed. Retest until all leaks are resolved.
Step 3 of 4
Install New Shower Hardware2 min