Assemble and Install Floating Shelf Sleeves

floating shell sleeves that will slide over it we're going to make it a three-quarter inch plywood i'm going to put it together make all the edges miter that way it looks like one solid piece and we'll stain it and then slide it on all right so these my dimensions every corner here is going to be mitered it's going to be 45 degrees on each side so i made a measurement of the inside giving about an eighth of an inch gap so it could slide on easily but i'm going to make all my cutting measurements because it's cutting at a 45 degree to accommodate the angle already so what i mean by it is by the time you make your miter you've added three quarters of an inch on the final outside dimension i added to every dimension either three quarter inches or inch and a half which is double the three quarter inches i'm not 100 sure about this here's the issue that i'm having it tripped this uh table saw the breaker burning all the wood so it's creating too much friction i'm gonna throw a brand spanking new blade on there 60 teeth is perfect for plywood especially cross cut so it doesn't chip out look at these teeth marks that's a sign of heat they're getting too hot too much friction and look how fresh these carbide teeth are [Music] so what we have here all three shelves the side pieces are done like this now we're gonna do the front piece now we have the fronts for all three shelves ready let's do the tops and bottoms for each one here's what we have we have our top and bottom mitered in the front miter on the side and flat in the back because that's going to be the back wall and then we have our front face which is mitered on all four sides we're going to use wood glue and brad nails to put it together use tape where we need it to make sure we have good seams and then once it's all dried we'll putty it up stain it sand it and slide it on how cool is this it actually worked out the dimensions are actually spot on i was expecting to really blow this i'm gonna start busting out two more of these let them dry overnight and then we'll get to sanding [Applause] [Music] [Applause] i'm gonna let them dry overnight tomorrow i'm gonna wood fill it sand it and get it ready for stain now that everything's ready we're gonna do some stain this is a semi-transparent uh weathered oak very popular with irena it's this one and fruit wood this one has the same little bit gray tones that the island has so it'll match the breakfast bar shelves to the island cabinets perfectly i'm going to…