Install New Wooden Support Blocking

it if we put it up a little bit higher it would be awesome right the problem is it's down so low that I mean really you've got to be pretty small to actually have that feature going for you so I've had a little bit of time to think about what I was going to do with this thing so I'm going to take this I'm going to screw this right on the edge of a piece of wood I'll shoot one screw in a little bit going this way that way I actually catch wood get these two solid and get this put back in place I'll shoot screws right here it's a little bit smaller than a piece of 2x4 I'll put one over here as well and then I'll put a piece of plywood right here and screw that together and that way we're actually going to skirt right behind this and we'll make this pretty solid and it should never come apart like that again like you can see I could try to notch a two by four this way as well and I could have done that but really I don't know I think the way that I'm gonna do it is going to end up being a bit better than this side up so all right so I got a piece of two by six that I kind of chopped up and trimmed down and I'll just end up taking this and instead of being right here on the edge we'll just go in a half inch that way I can actually put the piece of plywood right there afterwards and kind of secure it a little bit more okay well I'm just going to take my pencil kind of Mark see that's where the center is that's where the top is that way I just know whenever I shoot some screws in here that I'm going to miss that whole setup okay I want to get down low I want to get up high [Applause] you know pre-drill this real quick and should be good to rock and roll so here's how I was going to roll with this this is where the Block's gonna go I'm just going to hold this right in place bend it down this seems very convoluted it's really hard to do these things sometimes from the back side any ideas actually would be great but bam not that one not that one right there but these three right here pre-drill Bam Bam and Bam then I should be able to just screw those in place all right so my thought is I need three screws for that so I went with three inch and a quarter Torx bit and then I went with four three inch Torx bit to go into the sides here right to each there should be plenty should hook it right up I wish I had my impact I don't okay that looks good at least we got one on I don't actually know if you can see that we'll see oh you know what it was the bottom hole so crazy…