Skip to main content
Stesso

Remove or Punch in Wall Anchors

0:48
5:55
15.7K views

At 0:48 in

The ART of Touch Ups. Master Painting and Spackling Touchups.

Watch on YouTube

What happens here

Address existing wall anchors by either unscrewing them if they are threaded or by pushing them further into the wall. For press-in anchors, use a Phillips head screwdriver to punch the anchor inward. Alternatively, you can use a hammer or the back of a 5-in-1 tool to tap the anchor into the wall. This creates a slight indentation, allowing the anchor to be covered by spackle. After pushing the anchor in, if there's a raised 'volcano' effect around the hole, use the Len bite scraper to gently scrape it down until it's flush with the wall surface.

Goal: Address existing wall anchors by pushing them into the wall for a flush surface.

Tools and materials

  • 5-in-1 Tool — Tapping wall anchors into the wall
  • Hammer — Tapping wall anchors into the wall
  • Len Bite Scraper — Scraping down any raised 'volcano' effect around punched-in anchors
  • Phillips Head Screwdriver — Punching in wall anchors

What they say

Hide

so these are scraped down here's one right here where somebody build a hole right there but the wall anchors you can see there's a Wall anchor sometimes you could get a screwdriver in there and unscrew them sometimes they're just the pressing ones but I'll take a screwdriver like a Phillips head screwdriver punch them if you punch them in the wall now you can fill it up you can actually Hammer them in the wall so I can just bang it in but it that'll leave a bigger indentation the back of a five in one Tool The Hammer tool A lot of times I'll just hit it with a hammer knock it in um and you know get rid of it that way but it's going to leave a bigger indentation to leave a small indentation I'm just going to hammer that thing in the wall now it's you know inside the wall I don't want to hammer it all the way in because I have some backing for my spackle this one hammered a little bit too hard and so it fell in so there's no backing for the Spackle but after you Hammer them in you're going to have what we call like a volcano on the outside we're going to scrape the volcano and then we're going to fill it so scrape that and then we're going to touch this up right here now I'm just

Auto-generated from the video audio.