Grout and Final Clean
At 0:25 in
Remember this? It was hARTscape!..#hardscape #hardscaper #hardscapedesign
What happens here
Once all the irregular stones are laid and set, prepare the grout. This could be a traditional cement-based grout or polymeric sand. For cement-based grout, mix it according to the manufacturer's instructions until it reaches a consistent, workable consistency. Using a rubber grout float, spread the grout over the mosaic, pressing it firmly into all the gaps between the stones. Work in small sections. After applying, wait for the grout to slightly set (haze over), then use a damp large sponge to carefully wipe away excess grout from the surface of the stones, being careful not to pull grout from the joints. Rinse the sponge frequently in a bucket of clean water. For polymeric sand, follow specific instructions, which usually involve sweeping it in and then misting with water to activate it.
Goal: Fill joints, secure stones, and clean the mosaic
Tools and materials
- Buckets Lowe's — Holding water for rinsing sponges and mixing grout
- Large Sponge — Wiping away excess grout and cleaning stone surfaces
- Mixing Tool — Thoroughly mixing cement-based grout
- Rubber Grout Float — Spreading and pressing grout into the joints
- Grout — Filling the gaps between stones, securing them, and providing a finished look
- Water N/A — Mixing grout and cleaning tools/surfaces