Optimize Roller Pin Adjustment

machine is level right got another tip that I want to you know show you it's with these um rollers right here so the rollers on the outside I'm going to show you little trick and this was an issue you know I ran into the roller knot spin you know freely and causing a lot of drag when the picket or the uh Lumber was going through and it was actually tearing up the roller itself this the the foam roller and that is how this thing is actually attached it's so you got a pin center pin that goes through and then this thing the foam roller is on a sleeve right here right there just like that so it slides on this sleeve it's going to go down this is what holds it in place in order for this thing to spin freely inside the sleeve and have your foam roller spin freely the keepers that are attached to this sleeve have to have a certain portion exposed right here so I got about A4 of an inch exposed now it wasn't exposed and the keeper was sitting down there and the sleeve was actually inside when you slide this on the sleeve is going to be riding on uh the end of your pen right here it's going to cause drag and friction and what I noticed is it doesn't spin as freely because of the drag you know on that keeper right there so I want to make sure this thing is sitting up about A4 of an inch now there's going to be less drag sitting on the end of that right there and it's going to spin a lot Freer and it's going to be a lot easier and you're not going to D roller