Skip to main content
Stesso

Connect Water Lines and Test

0:57
1:01
12.7K views

At 0:57 in

Please Mount Your Faucet On Flat Surface! #helpingothers #diy #plumbing

Watch on YouTube

What happens here

Finally, connect the new faucet's water supply lines to the hot and cold water shut-off valves under the sink. Use an adjustable wrench to securely tighten these connections. Once all connections are made, slowly turn on the water supply and thoroughly check for any leaks around all new connections and the base of the faucet. Address any leaks immediately by tightening the responsible connection slightly.

Goal: Complete the plumbing connections and verify the installation is leak-free.

Tools and materials

  • Adjustable Wrench — Tightening water supply line connections

What they say

Hide

There's put right down in there. Put the washer and the nut on. Not super tight because you need to center this. Once you get that set up and you know it's straight, just give it the final snug with this. This bad bleed is all hooked up. Get this tightened down.

Auto-generated from the video audio.