Prepare Sprayer and Product for Application

1:58

6:41

7.5K views

At 1:58 in

Master Airless Spraying. Tips To Become A Master Level Sprayer.

Watch on YouTube

What happens here

Pour the Valspar Protective Sealer into a clean bucket. Place the intake tube of the airless sprayer into the bucket with the sealer. The sprayer being used is a TriTech T4. Configure the sprayer to run at a super low pressure, ideally between 800-1100 PSI, which is typical for HEA (High-Efficiency Airless) tips. The goal is to achieve product saturation of the block without excessive atomization, which would create unnecessary overspray and product waste. A fine-finish tip, specifically an HEA 311, is used for this purpose to ensure sufficient material delivery without high pressure.

Goal: Set up the airless paint sprayer by placing the product intake in the silicone sealer and configuring the sprayer settings for low-pressure application using a fine-finish tip to saturate the block without atomizing the product.

Tools and materials

HEA 311 Fine Finish Tip
Paint buckets
Pressure gauge
TriTech T4 Airless Paint Sprayer TriTech

What they say

(823 characters)

Hide

just spraying it just reuse it a tri-tech keyboard sprayer and just we sprayed it on all you're going to do is spray it on and that's it we're going to take it all the way down to the puddings because we want a weatherproof waterproof the same all the way down to the ground so I'm just going to be using just a fine finish tip low pressure don't need to atomize the product just need to get it on saturate the block so so I don't want to be out of my advising this product not going to be running a high pressure super low pressure I'm just going to be using an hea 311 tip to spray this product on I don't want a lot of overspray it's not windy out here it gets super windy out here at the Bruno sand dunes but today it's calm morning so far the h8 tips supposed to run around 800 to 1100 PSI mask off the metal door jamb

Auto-generated from the video audio.