Skip to main content
Stesso

Reassemble Shower Valve

0:43
1:00
15.3K views

At 0:43 in

Is Your Shower Not Getting Hot Enough? #diy #helpingothers #plumbing #moen

Watch on YouTube

What happens here

After adjusting the white rings, carefully place the black cap back onto the valve assembly, ensuring it's properly aligned over the internal components. Reinsert the screw into the center of the black cap and tighten it securely with the screwdriver. Finally, place the shower handle back onto the valve stem, aligning it as desired, and tighten the set screw clockwise using the Allen wrench until the handle is firm and does not wobble.

Goal: Put the shower valve components back together

Tools and materials

  • Allen wrench — Tightening the set screw on the shower handle
  • Black Valve Cap — Re-covering the valve
  • Screw — Securing the black valve cap
  • Screwdriver — Tightening the screw for the black valve cap
  • Shower handle Moen — The main operating lever for the shower

What they say

Hide

You just simply remove those. Just make sure these two little knobs are lined up with each other, and you're going to have good hot water flow. This was the issue. Put our sensor on top of our Allen wrench, get that all tightened up. Now we'll give it a test. Yeah, it already goes way further over. That's already starting to steam up nicely for us. Good to go!

Auto-generated from the video audio.