Skip to main content
Stesso

Install Pin and Sleeve Connectors and Terminate Breakers

0:38
0:53
489K views

At 0:38 in

Installing 3 New Network Racks Inside a Data Center, Thoughts? @dewalttv

Watch on YouTube

What happens here

After the cables are routed and the RPP is prepared, proceed with installing the electrical connectors. Install 6-pin and sleeve connectors at the ends of the MC cables that will connect to the new network racks. These connectors are typically left under the raised floor for the IT personnel to connect once the racks are in place. Simultaneously, terminate the other ends of the MC cables into the appropriate circuit breakers within the Remote Power Panel. This involves stripping the wire insulation, inserting them into the breaker terminals, and tightening them to the manufacturer's specifications. Once terminations are complete, verify all connections for secure fit and proper wiring.

Goal: Provide secure and powered connections for future network racks.

Tools and materials

  • Continuity Tester / Multimeter — Verifying correct circuit connections and absence of short circuits
  • Screwdrivers — Tightening terminal screws on breakers and connectors
  • Torque Wrench — Ensuring terminal screws are tightened to manufacturer specifications
  • Wire Strippers — Removing insulation from electrical cables
  • 6-Pin and Sleeve Connectors — Providing robust and secure power connections for network racks

What they say

Hide

new network racks. RPP stands for remote power panel. My dad is using a DeWalt drill with a stepper bit to make a knockout inside the panel so we can feed our wires. We got our wires ran to the locations, installed six pin and sleeve connectors, and left the plugs under the floor so when the IT guys come to put the new racks in, they got power. Breaker terminations complete. Job complete. Customer satisfied. I put my tools away, and that's what a day looks like as an electrician.

Auto-generated from the video audio.