Masking and Protection

process. We're going to begin masking everything, getting everything masked off our walls, cabinets, inside the cabinets. We got get them all completely masked, and we're going to show you that lacquering process. going to be using a 3M hand masker with 2021 in tape, 9 in paper, and then 3M masking film to get this thing ready to go. So, we're going to begin loading up our sprayer with our lacquer. We're going to be using this product from Sher Williams, Sherwood Pre-Cat High Build Lacquer. We're going to be using a medium rubbed effect, and we're going to be using our Titan 440i to spray these cabinets. Getting ready to lacquer these cabinets, and we've got the inside all masked off. We're going to be spraying the the drawers outside on the deck. Got a drop cloth down. Got our 440 set up inside a 440i. Set it very low pressure. We're using a Rackex 310 tip to spray these. And we're just going to put a really light fog coat on first as our first coat just to seal our glaze on there. And then our next coat, our final coat's going to be a lot heavier and a little bit slower uh uh coat. And so we want it to be be nice and thick and gel out nice and thick. So you can see I'll show you how we're just going to do a quick light fog coat on here. And just going to be sealing the glaze on. So it's just going to be some really quick strokes very fast. It's just really light. A really light coat. That's your first fog coat to seal on your glaze. our cabinets all glazed, ready to be lacquered. Now we're going to be spraying on our first coat of lacquer. Going to be a first fog coat, thin coat. Then we're going to spray on our second coat. After that, about 10 minutes later, it'll be our final coat. Got everything all masked off plastic and paper to keep all the overspray off our walls, off the countertops, and inside the cabinets. Set and drop cloths down on the floors to protect our tile. Got paper down. Two layers of paper on the floor. Keep everything off the floor. Just also set some drop cloths down covering our floor so we don't get any overspray on our floor either. Got everything all covered with plastic now. Everything's prepped, ready to go. Covered with plastic and paper. be putting paper so we don't get any overspray inside of our cabinets. We're going to be covering our the drawer guides with tape so we don't get any lacquer onto the drawer rollers. Draped plastic over the cabinets so we don't get any dust inside the cabinets. Going to be we put paper…