Assemble and Glue New Section

okay so we'll start gluing this up this is flogar gold medium yellow all-weather one-step cpvc cement right this is primer and glue in one this is kind of just what i use it works pretty well and we're just going to begin just make sure you get up in there a nice thin coat around the whole thing it's like regular pvc or abs or anything else you want to give it a quarter turn you want to hold it you want to make sure it doesn't pop out okay so now we're gonna go ahead and we're going to glue uh this piece on here just make sure it's back away from all that insulation get yourself a nice coat on there one side of your coupling okay so it didn't go on right away make sure you re-glue if you see an edge that is not covered just make sure you put some more glue on it you can wipe the access off there a little bit we're gonna stick this piece of pipe right through here and then we're gonna glue here and glue here and then we'll just stick that in there that way that's gonna work we're not gonna get glue all over that and we'll get it set up and then we can actually just come right here we can cut this for the proper length that we need okay you see this right here we need to get a measurement from here to the bottom of this board because that's where this next 90 is going to go so to do that i mean i'm just going to make this very simple and easy to follow along right if you take this and you put this right up against it because that's essentially where that's gonna go go to about two and a half right there i didn't bring a pencil with me but then we just got this ratchet cutter right as long as you kind of let it sit there and put in the cradle it's going to cut it nice and flush and just be hooked up all right so now we put this side in here with this right here and all glued up it should actually be right at the same height as that but now that we actually have this right here in place now i can cut this piece right here to length so now to get this length right here what we're gonna do is we're actually just going to measure this other pipe right here so off of this board over to right here will tell us exactly what this pipe needs to be cut to right so if we come up here and we go to right there all right there needs to be cut to two and three quarters off of the stud i didn't bring a pencil so we'll just go to right there nice just dropped that tape measure in the bucket well i kind of made a mark right there so let's see if our mark is correct and then we…