Verify Correct Air Distributor Plate Orientation

in here I'm holding it up are at 12 and 6:00 and if I flip it around so you can hopefully can see that in the video you can see that you can see through the slots in the back of the fan control that's important because when I flip it around and I have it I put it in backwards you can see that when I when I put it in backwards that the uh disc or the air distributor plate is actually blocking the air from coming through these slots in the back of the fan control ring and that's going to block off all of your Air Supply going to the ears of the air cap which basically only gives you a round pattern right so that's very common the easiest way to tell if you put it back together and you have the fan control ring where your slots are at 12 and 6:00 but then when you put the air distributor on it your your slots are now at 3 and 9:00 right right and so that's blocking the holes off so what we want when we put this all back together is to have all of the slots at 12 and 6:00 so when I hold that up again we have all the air that's able to go from the back through into the front of the gun so that it's feeding the air evenly to the uh ears and to the center hole in the air cap and that c that small circular hole that's going to line up with the pin with the pin on the back here yeah so all of this is aligned with the pin and the only thing the pin does is just stops this whole assembly from rotating in the spray gun so that