Reassemble the Air Distributor Assembly

from rotating in the spray gun so that when I turn the ring I'm not going to rotate the whole assembly I'm only going to just rotate the ring because it's that it's that ring and I don't know again if this will come out in the video but it's that ring when I rotate it it closes off the holes and that's how it air distributes the air to the ears or basically controls the fan pattern width all the way down to a round pattern so by shutting the air off to the ears of the air cap we force the air all the way through the center hole and that just gives you a round powder and then this pin that your head there that's going to line up with the hole in the face of the gun so this whole assembly usually comes off in one piece and I usually put it back together in fact I'll just drop the nozzle in here as well and it makes it real easy because then you can just drop this whole assembly onto the front of the gun and then just kind of wiggle it until you feel it drop into the hole and now you have it all lined up and I can just tighten down my nozzle so you're going to tighten down your nozzle now now fingertight and then just a little bit on the wrench not too much and now when you put the gun back and you go back to spray you'll have your full fan width control and be able to have all the different widths of fan pattern including your round pattern yep so there you have if you've ever run into that problem like I have and now you understand you know how to resolve it you understand how to install the distributor plate air distribut PL air distributor plate 12 and six is um something an easy way for me to remember to install it correctly every single time so I don't have to tear it apart and reinstall it if you got any questions or comments about this video just leave it down in the comment section below we'll try to answer them as soon as we can and we'll see you next time right here on paint Life TV out