Skip to main content
Stesso

Reassemble Spray Gun Front

3:28
4:34
881 views

At 3:28 in

Fan Control | Troubleshooting Issues With the 77000 Atomizer Spray Gun

Watch on YouTube

What happens here

After ensuring the air distributor plate is correctly oriented within the fan control ring assembly, carefully reassemble the spray gun. The entire assembly, including the nozzle, air distributor, and fan control ring, can often be dropped onto the front of the gun as one unit. Make sure the small pin on the gun's body aligns with the corresponding hole in the assembly. Gently wiggle the assembly until it drops fully into place. Then, finger-tighten the nozzle to secure the components. Finish by using a wrench to give it a slight, final tightening, being careful not to over-tighten.

Goal: Reassemble the spray gun's front by dropping the correctly aligned components into place and tightening the nozzle.

Tools and materials

  • Wrench

What they say

Hide

gives you a round powder and then this pin that your head there that's going to line up with the hole in the face of the gun so this whole assembly usually comes off in one piece and I usually put it back together in fact I'll just drop the nozzle in here as well and it makes it real easy because then you can just drop this whole assembly onto the front of the gun and then just kind of wiggle it until you feel it drop into the hole and now you have it all lined up and I can just tighten down my nozzle so you're going to tighten down your nozzle now now fingertight and then just a little bit on the wrench not too much and now

Auto-generated from the video audio.