Skip to main content
Stesso

Final Tightening and Testing

0:51
1:02
43.8K views

At 0:51 in

Easy Fix For A Hose Bib With Built In Vacuum Breaker! #diy #plumbing #homeimprovement #homerepair

Watch on YouTube

What happens here

After hand-tightening the new cap, use the Knipex Cobra pliers to give it a final slight snug turn (clockwise) to ensure a secure, watertight seal without over-tightening the plastic. Then, turn on the outdoor faucet fully. Observe the newly installed vacuum breaker cap for any leaks or drips. The video confirms no leaks and proper water flow. Finally, replace any decorative cap that may have been removed and reattach the garden hose.

Goal: Snug up the new vacuum breaker cap with pliers and then test the faucet for leaks and proper operation.

Tools and materials

  • Knipex Cobra Pliers

What they say

Hide

this out. These are the same. This actually has a place to turn it. Let's get that little part of the valve facing up. Screw that down on there. Pretty much can just go handtight and it's going to be fine. We'll just hit it just to snug it up just a little bit. So, that's it. It's not leaking. It works. Screw that cap on. Put his hose back on.

Auto-generated from the video audio.