Set Up and Operate Texture Sprayer

2:27

8:16

658.9K views

At 2:27 in

Drywall & Sheetrock Texturing Hacks. How To Spray Texture A Wall.

Watch on YouTube

What happens here

After mixing, transfer the prepared texture mud into the hopper of the Tech Spray texture machine. Understand the controls of the texture sprayer: a switch to select between gun and hopper material source, a material flow dial (often run at full flow for efficiency), and an air flow gauge (adjustable to control spray pattern and consistency). The machine also has interchangeable tips for different texture types (orange peel, acoustic, knock down). For orange peel, a light tan tip is typically used. For detailed operation of the machine, including controls, refer to a dedicated video on operating a texture machine. Once the machine is loaded and settings are confirmed, practice spraying on a scrap board to fine-tune the texture before applying it to the wall.

Goal: Prepare and understand the operation of the texture spray machine.

Tools and materials

Spray Tips — Creating specific texture patterns (e.g., orange peel)
Texture Gun Graco TexSpray — The hand-held device for spraying texture
Mixed Texture Mud Sheetrock Brand — The prepared texture material to be sprayed

What they say

(1,778 characters)

Hide

before we dump it in there so we got our texture sprayer set up right here and got our mud all mixed up to the consistency we want and these texture sprayers are actually pretty simple to use i do have a video on actually how to operate the machine specifically with the controls and we'll go over that in detail if you want to see that video you can click on the video right here we're just going to show you briefly though here some of the functions of this sprayer i'm just going to show you us spraying this patch right here that we did and the texture sprayers got just a couple dials and it's got a switch right here that we can take and run the gun itself and we can run the mud our texture through the machine and directly right through the gun onto our surface or you can actually use a hopper that you can put on the gun and actually run your mud right through a hopper so you can have it with you and that's we're doing a little bit small repairs we typically never use the hopper we're always just loading it right into our machine and using it so you got that switch to switch it from gun to hopper and then you've got a flow control to adjust the amount of flow and the material that's actually coming out of the gun and then we have an airflow that we adjust the air on the gun too and it's pretty simple to use just turn it on you just play around with those controls you get the proper consistency or the proper texture that you want and then once you get it that you want we actually practice spraying it on a board or something and then we'll begin spraying on our project and right here we're just going to go along and spray an initial texture across our patch that we did and then we're going to begin after that's dry we're going to texture the whole wall

Auto-generated from the video audio.