Install Seating Supports

in there we still have to finish off the bottom seating area to create the supports that basically would act like that box spring that way the cushions don't fall through first I'm gonna create a frame around it and I'm gonna do is cut a board 69 inches long and then rip it exactly down the middle on my table saw I'm gonna add some wood glue and to secure it flush recessed on inner parts of the bottom seating area basically this is a box spring at this point then I'm gonna pick up three boards that are six feet long of the one by four common wood you could also even use scrap plywood if you have a lot of it left over at the house from previous projects and then you just gonna secure them on the both the front and the back side from the top with one and a quarter-inch regular screws you don't even have to use wood glue for this part it's just for that support once this place we're ready to start doing the finishing on this project sand off all