Cut-In and Back-Roll Crown Molding and Trim

3:33

12:49

2.1M views

At 3:33 in

CUTTING CEILINGS. DIY How To Paint A Straight Ceiling Line.

Watch on YouTube

What happens here

For intricate areas like crown molding or above door frames, the technique is similar but requires even more precision. Load your brush minimally, using only the very tip of the bristles. Place the brush about 0.5 inches from the molding or trim and then slowly work it up to touch the edge, effectively drawing a line. Drag the brush along the trim in one direction, then reload, and drag back in the opposite direction. This ensures that the paint fills in any textured areas. For crown molding, pay close attention to the details of the trim, using the brush's tip to navigate curves and edges. For areas above door frames, apply paint with the mini-roller to fill in the space, as this makes it easier for the person rolling the main walls to blend their work. Remember to back-roll these areas immediately after brushing to maintain consistent texture.

Goal: Achieve precise paint lines around detailed trim and blend textures.

Tools and materials

4-inch Roller Nap Purdy White Dove — Back-rolling to blend texture

What they say

(1,435 characters)

Hide

And if you're new at cutins, don't got a lot of practice, it's good to hold your breath. Just pat it. Just hold your breath the opposite direction. If you got to lay it out again, one more time. Lay it out again. Then I'll cut it in again back the opposite direction. And I can do about three or four feet and then roll. So just pat your brush. Don't dip your bristles too far in. You want to dip your bristles just about an inch. One direction. Go back the other direction. Just use the very tip of the brush to get up there. And you're basically drawing a line. So I can get about several feet then go back roll it. bristles in just an inch to/ inch. Just tap it on the side just to load up your brush. Going to take I'm going to place my brush about a half inch from the ceiling. Then I'm going to work it up. Just glide it right along. It'll go about a foot or so and dip it back in. And just gonna get right here. Work my way up to the ceiling. I'm going to just back roll it. When I back roll it, I want to get about about an inch to half inch from the ceiling. Just like that. Got another section above a door here. You just fill that in to make the person rolling with an 18in map or 9 in map a little easier so they don't have to work above doors. Once again, I'm going to take place my brush about an inch from the ceiling. And then I'm going to glide and then get it right up against the ceiling back the opposite direction.

Auto-generated from the video audio.