Skip to main content

Modify Plumbing for Integrated Sink

8:09
22:32
420.8K views

At 8:09 in

Completely Gutted Our Laundry Room

What happens here

Tools and materials

  • Drill (Ryobi)
  • Drywall Screws
  • Joint Compound
  • Level
  • PEX Crimping Tool (Ryobi)
  • PVC Cutter
  • Pencil
  • Reciprocating Saw (Ryobi)
  • Safety Glasses
  • Tape Measure
  • 3-Way Sanitary Tee (PVC)
  • Drywall Patches
  • PEX Crimp Rings
  • PEX Tee Fittings
  • PEX Tubing (Hot & Cold)
  • PVC Cement
  • PVC Pipe and Fittings

What they say

Hide

how cool does that look it looks so nice so clean good morning guys uh we are refreshed and ready to tackle the plumbing an electrical situation that i know is going to be a headache i've already started cutting some drywall out but i need to do some more so we're going to need to add a water supply and an adequate draining for the sink that will be here in the 24 inch cabinet what i figure we're going to do is we're just going to chop this off chop that off throw this piece away and then we're going to add a three-way sanitary drain that way we'll have this part basically mirrored here we'll keep our vent and then for this one we'll add the drainage for the new sink i've realized this is going to be the hardest time try to create these cuts with such narrow room to be able to fit these pipes so i think what i'm going to do is i'm going to chop this down here remove that fit all the plumbing perfectly and then i'll just build a little nice box frame around it so i could secure drywall i'm going to do this little extension piece um just because there's a gap here add the cement on push it in things when there are vent tubes like this there's flex because it's going up into the attic so this is going to be here as you can see this is our drain for the washer it needs a p-trap so we'll have it here that was the original one put a little extender piece and that should be good now that we have the drain for the washer we'll do the drain for the sink uh this is a 90 degree long span elbow just to get an eve easier flow the moral of the story with plumbing is to cut down all the turbulence for drainage all right up next we're going to start doing the water supply line for the faucet you get a little holder like this for the the water supplies these are copper jade lines they go in here secured in place with these little caps they tighten it in place usually i've always used the hand clamping uh but i got this we'll see how it looks we're gonna use these uh tees they're gonna go in place like this with the pex rings and the pecs crimped in place and then we'll be able to connect them over there because there was not enough room to tap into this line i had to do a little detour around works perfectly fine totally okay we'll take this outlet off piggyback the cable down over close this off when we're done [Music] so the plumbing is all done we're just

Auto-generated from the video audio.