Clean Gun Filters

the next time one other step that we we're going to be doing when cleaning our sprayers also cleaning the gun filters so either clean them when you clean your sprayer or clean them when you show up the job site to start spraying so a couple safety things you definitely want to turn the sprayer off pull you we got two guns here pull your gun trigger we're going to release any pressure on the gun we'll release pressure on prime valve um so we're going to hold prime valve release that pressure now this gun right here a tool-less gun right here to to get to the filter gonna release the handle right here and then now this actually attaches to that portion right here like a wrench and that thing's gonna unscrew it's going to loosen up a little bit like that it's going to drop down so then you can start spinning the top and just thread it right off and that's going to expose our gun filter so you can see this gun filter was completely clean today that's what was going through our paint that's why you strain your paint so we never strained our paint today just to test out our paint to see what would happen there you go that gun right there we didn't use that one very often much today so it doesn't have as much but you see all that so now we're going to clean these things off um use a hose i can i like to clean you want to clean down inside there you want to clean the filter off so i'm going to turn the hose on and then we'll clean these off right here thing is if you don't if you don't clean your filters out and you get too much stuff built up on them right here there'll be a lot of pressure on the mesh of this filter and it'll split the mesh open ruin the filters so you should be cleaning them every day and then you should also be straining your paint because this is how much debris just went through um just a little bit of spraying today not just two gallons of paint so clean those off really good run some water down inside this portion of the gun there you go i don't like to submerse my guns in water because typically you end up having issues with them sticking run some down in there i like to run mike there's a a nylon seat down in there i like to run my finger on that seat clean that these are just push in filters on the rx pro gun so it just pushes in and it sits in there and just stays in there once it's once it's cleaned so today we were painting with a product and a montage paint which is an upcycled recycled and up-cycled paint and nowadays it's common…