Rip Cut Lid Slats with Miters

to cut it out all right the end caps are done we're going to stay on the subject of lid and we're going to discuss how we create this radius curvature throughout the entire lid the 20 and a half inch long pieces we need to rip them into two inch wide strips to allow for the bend now that 90 degree angles they're still not enough for us to continue that curvature smoothly so we need to cut them off a little bit what i found that works best if we create a mitered rip cut using our table saw with the degree that's between 5 and 13 degrees you can pick a number but that will allow for you to actually give you enough room to continue the flow of the radius pattern throughout the entire lid now that we