Skip to main content
Stesso

Drill Dowel Holes

5:06
14:05
116.6K views

At 5:06 in

Building Expensive Coffee Table on a Budget

Watch on YouTube

What happens here

The presenter marks the locations for the four dowel legs on both round wood blanks. For the bottom tabletop (the lower tier of the coffee table), through-holes are drilled. For the top tabletop, partial depth holes (2.5 inches deep) are drilled to house the dowels without going completely through the surface. A Forstner bit is used for clean, flat-bottomed holes, and painter's tape is applied to the bit as a depth stop for the partial holes.

Goal: Precise locations are marked on both tabletops for the dowel legs. Holes are drilled using a Forstner bit; through-holes on the bottom tier and partial depth holes on the top tier, ensuring a clean and secure fit for the dowels.

Tools and materials

  • 3/4 inch Forstner Bit
  • Clamps
  • Cordless Drill
  • Measuring Tape
  • Pencil
  • Painter's Tape Scotch

What they say

Hide

okay the next thing is we're going to create these holes that are going to accompany the dowels to go in right so they're going to have four of them one on each side they're two and a half inches recessed inside we're going to use our third tool and hopefully our final tool a drill with a forstner bit it this is just three quarters of an inch the thickness of the dowel any kind of bit will do this just creates a cleaner cut the first set is going to go all the way through the second set is only going to go partially halfway through i'm going to create a little stop marker with a piece of tape so i know when to stop and then we'll uh we'll get ready [Applause] [Music]

Auto-generated from the video audio.