Reinstall Baseboards and Add Vertical Battens

something to be looking out for okay so yucca board is on perfect um this is gonna be a unique transition and i'll show you how i'm gonna address it it's still a little fuzzy in my head how i'm gonna exactly do it but uh we're gonna throw the baseboard back here this baseboard is going to go up to here but first i need to throw some styles it's a little confusing because they're going to have to do a few transitions but baseboards styles and then the rest of the baseboards you want to peel off any of this old caulking that's on there it'll make for a better tighter seam and less ugly [Music] what we'll do next we're going to finish off the rest of the styles vertically planning them out to be about 16 inches on center that's about what your studs are we'll throw one in the corner start off and then line them off from there before we start putting the tops on wherever we have these seams that's one there and there's one here i didn't pre-plan to make sure the pattern's consistent entirely hard to think that far ahead so here i kind of figured out that as long as from tip or edge to edge is 21 and a half this could be an even pattern it kind of continues over here but then this wall is a little tricky there's no seam on this one but there's a seam here meaning this one's going to dictate what we do there long story short i can get all these to be the same measurements but these outer ones they might be a little off but i'll do our best to conceal it best we can [Music] styles looking fantastic made it work exactly how we want it uh here's the next thing we got to do we're doing the one by two put it on its side then a five inch piece there and then another 1x2 these transitions are going to be our hardest and so we're going to save that all well i don't know how much towards the end we could save it this one definitely has to be tackled right now i couldn't