Skip to main content
Stesso

Prepare Airless Sprayer and Stand Doors

5:47
12:59
267.9K views

At 5:47 in

BEST Way To Paint Doors. AIRLESS SPRAYING.

Watch on YouTube

What happens here

The airless sprayer (a Titan 410 Impact) is prepared by first running soapy water (Dawn dish soap) through it to clean out any previous contaminants. This is followed by running clean water to flush out the soap. The presenter will be using a Titan Fine Finish 410 tip, a purple-colored tip specifically designed for achieving a smooth, automobile-like finish. The sprayer pressure is set to approximately 2300 PSI. Before spraying, the doors are removed from their hinges and placed on steel door hangers (available from TheIdahoPainter.com) to allow for spraying both sides simultaneously. The metal weather stripping on the doors is also masked off.

Goal: The airless sprayer is cleaned and set up with the appropriate tip, and the doors are positioned for spraying.

Tools and materials

  • Buckets (2)
  • Steel Door Hangers
  • Titan 410 Impact Airless Sprayer Titan
  • Titan Fine Finish 410 Tip (purple) Titan
  • Dawn Dish Soap Dawn
  • Painter's Tape

What they say

Hide

cleaned out make sure there's no contaminants inside the sprayer from its previous use this is just soapy water so I could just spray right out here now I'm just gonna take and run clean water got the soapy water we'll just run it some clean water through it now without soap all right so I'm gonna get ready to spray these doors I'm gonna be using I got to a Titan 410 impact sprayer right here doesn't have a pressure gauge so I'm just gonna have to go by feel I'm spraying with an Rx pro gun I'm gonna be spraying these doors I want a fine finish and automobile like finish so I'm gonna be using titans fine finish tips these purple tips I'm gonna be using a 410 tip that is one of their fine finish tips so I'm gonna load up my paint and we'll get that process going here I'm gonna then I'll once I get my paint loaded up I'll stand up my doors and get them ready go so just got about just got it almost ready this Wraith mouth stop that piece of metal I don't want to get any paint on the weather strips down here so I'm gonna you know just mask those weather strips off down here and then we'll be ready to spray so I'm getting ready to spray the doors now got my gun sprayers all set up using once again a 410 tip I've got it dialed in it's running around 2,300 psi safety is always first important got a respirator wearing some eye protection if you're ever doing any airless spraying I always keep in my wallet on an injection card this is very important if you ever get injected you can actually lose a limb or die so make sure

Auto-generated from the video audio.