Almost Like New Vacuum Cleaner Hose Fix! #diy #helpingothers

This is our Bissell Spot Clean Pro. This hose is starting to split. So, you just got to work both sides of this where both of these tabs are. Don't want to clip that. So, let's pop this part of the handle off. A little clamp that's actually holding this hose on, and then you can just slide that out of the way. It's going to cut around it. Give it chop. Grab the wire piece and just start pulling. A little bit of ABS glue. This is lefty loosey to tighten. Put that hose back through that hole. Dimple right there, we're going to put it into that divot, and it's going to actually click right in place. We're going to want to push this fitting on. Then you're able to just take your clip. So, then that just sits down in there. The button locked down on those two little slots. Take this piece, clip that back on. Let's give this bad boy a test. Check and see if there's any leaky leaky. No moisture whatsoever around that. We're good to rock and roll.