Skip to main content
Stesso

Conduit Bending and Routing

0:19
1:09
16.7K views

At 0:19 in

50 AMP Tesla Wall Connector Install for CyberTruck⚡️ Thoughts on Install and what would you charge?

Watch on YouTube

What happens here

One electrician begins the crucial task of bending 3/4-inch Electrical Metallic Tubing (EMT) conduit. This involves using a conduit bender to create precise angles and offsets to route the conduit neatly along the wall from the electrical panel to the desired location of the Tesla Wall Connector. The goal is to keep the conduit in one continuous piece for a clean and professional appearance, avoiding unnecessary couplings.

Goal: Run 3/4-inch EMT conduit from the panel to the charger location

Tools and materials

  • 3/4-inch EMT Conduit Unspecified — Protecting the electrical wires and routing them neatly
  • Conduit Bender Klein Tools — Creating precise bends in the EMT conduit
  • Level Unspecified — Ensuring the conduit runs are straight and level
  • Tape Measure Unspecified — Measuring conduit lengths and bend points

What they say

Hide

me up cuz he knew we get the job done and a quality install. He wanted next day service, so I sent over the quote and he accepted faster than Lightning McQueen. So here we are. My bro Ken started bending the 3/4 in EMT pipe. Yeah, 3/4 in conduit bending, guys. It's an arc. You can cut it and you can make an offset, like a little offset right here. But I'm trying to keep it one piece. >> Yeah. >> So, we start getting to business. I start mounting the Tesla charger on the wall and my bro Kim was terminating the circuit breaker in the panel. All right,

Auto-generated from the video audio.