Dry Fit Molding Sections

Intermediate3 mins

Part of project

Crown Molding Installation · Step 4 of 9

Helpful?

In this video

Protect the corners with a metal corner bead. Cut the bead with tin snips, leaving it about 1/2 inch short. Hold it tight against the corner. Because screws will distort the bead, nail it in place, placing screws every 9 inches.

Lowe's Home Improvement

1.3M subscribers

Transcript

Hide

Protect the corners with a metal corner bead. Cut the bead with tin snips, leaving it about half an inch short. Hold it tight against the corner. Screws will distort the bead, so nail it in place, placing screws every nine inches.

Auto-generated transcript. May contain errors.

Dry Fit Molding Sections

Expert

3 days

Part of project

Crown Molding Installation · Step 4 of 9

Was this clip helpful?

In this video

Protect the corners with a metal corner bead. Cut the bead with tin snips, leaving it about 1/2 inch short. Hold it tight against the corner. Because screws will distort the bead, nail it in place, placing screws every 9 inches.

Based on content fromLowe's Home Improvement· 1.3M subscribers

Video Transcript

(230 characters)

Hide

Protect the corners with a metal corner bead. Cut the bead with tin snips, leaving it about half an inch short. Hold it tight against the corner. Screws will distort the bead, so nail it in place, placing screws every nine inches.

Transcript may be auto-generated and contain errors.