stesso

Project

With the galvanized pipe ends prepared, you can now install the transition fittings. Since we are using push-to-connect fittings, take the fitting and the small plastic depth gauge that came with it. Hold the gauge against the end of the cleaned pipe and use a marker to make a line on the pipe at the edge of the gauge. This mark shows how far the pipe must be inserted into the fitting for a secure connection. Now, take the push-to-connect coupling and push it firmly and squarely onto the end of the galvanized pipe. You may need to twist it slightly as you push. Continue pushing until the fitting reaches the depth mark you made. You should feel a distinct 'click' as the internal grab ring seats properly. Repeat this process on the other end of the galvanized pipe.

You're viewing a step from: How to Replace a Section of Galvanized Pipe with PEX

Beginner

30 minutes

2/4 Inventory

This guide provides comprehensive, step-by-step instructions for replacing an old, corroded, or leaking section of galvanized steel water pipe with modern, flexible PEX (cross-linked polyethylene) tubing. The process involves shutting off the water supply, cutting out the problematic galvanized section, preparing the remaining pipe ends, and connecting the new PEX pipe using appropriate transition fittings.

Based on content fromHandy Man· 29K subscribers

Frequently Asked Questions

How difficult is this project for a DIY beginner, and how long should I expect it to take?

This project is rated for beginners, but it requires careful attention to detail and precision. For replacing a small section, a DIY beginner should realistically budget 2-4 hours, accounting for material gathering, preparation, and thorough leak testing. Factors like pipe accessibility and unexpected issues can extend this timeframe.

What are the most critical safety precautions I need to take when cutting old galvanized pipe and working with water?

Always shut off the main water supply and drain the lines completely before attempting any cuts. Wear appropriate personal protective equipment (PPE), including safety glasses, work gloves, and hearing protection, especially when using a reciprocating saw. Be prepared for residual water and rust flakes to emerge from the old galvanized pipe, and have a bucket and rags ready.

Do I need all the specialized tools listed, or can I use more common alternatives for this PEX replacement?

While specific tools like a PEX pipe cutter and depth gauge are highly recommended for clean, accurate, and reliable PEX connections, some alternatives can be used. A reciprocating saw with a metal-cutting blade is ideal for galvanized pipe, but a pipe cutter can work if space allows. Avoid using a hacksaw for PEX as it can create burrs, hindering a proper seal. Investing in the correct tools minimizes common mistakes.

What are common mistakes DIYers make when connecting PEX to galvanized pipe, and how can I ensure a leak-free joint?

A common mistake is not properly preparing the galvanized pipe end (e.g., failing to clean threads thoroughly, not applying enough pipe dope/Teflon tape) or not fully seating the PEX into push-to-connect fittings. Ensure the existing galvanized pipe end is clean, dry, and free of burrs. For push-to-connect fittings, use a depth gauge to mark the PEX, and push it firmly until it bottoms out inside the fitting, then give it a slight pull to confirm engagement. Test all new connections meticulously before finishing.