Cut Drywall Opening — Cut Out Existing Wall Material

Beginner2 mins

Part of project

How to Add a Door to an Under-Stair Closet · Step 2 of 6

Helpful?

In this video

Before cutting, use a screwdriver to carefully punch a small hole at a corner of the marked opening to check for any hidden obstructions such as plumbing or electrical wiring. Once clear, use a drywall saw to cut along the marked lines. For cleaner cuts and to prevent chip-out, it's recommended to cut on the downstroke or towards the wall, backing the saw out on the upstroke.

165.4K views2.8K

Transcript

Hide

pencil when choosing a location for your picture frame make sure and check that in the wall cavity you intend to put it in that there isn't any type of Plumbing or electrical that'll get in your way I used a drywall saw to plunge in to make my cuts if you notice I only cut on the downstroke or towards the wall then when I pick up the saw I back it off pull it out and then push it back in a little bit to avoid chip out of the

Auto-generated transcript. May contain errors.

Cut Drywall Opening — Cut Out Existing Wall Material

Advanced

2 days

Part of project

How to Add a Door to an Under-Stair Closet · Step 2 of 6

Was this clip helpful?

In this video

Before cutting, use a screwdriver to carefully punch a small hole at a corner of the marked opening to check for any hidden obstructions such as plumbing or electrical wiring. Once clear, use a drywall saw to cut along the marked lines. For cleaner cuts and to prevent chip-out, it's recommended to cut on the downstroke or towards the wall, backing the saw out on the upstroke.

165.4K views2.8K

Video Transcript

(428 characters)

Hide

pencil when choosing a location for your picture frame make sure and check that in the wall cavity you intend to put it in that there isn't any type of Plumbing or electrical that'll get in your way I used a drywall saw to plunge in to make my cuts if you notice I only cut on the downstroke or towards the wall then when I pick up the saw I back it off pull it out and then push it back in a little bit to avoid chip out of the

Transcript may be auto-generated and contain errors.