Skip to main content
Stesso
BrowseFeedExpertsMy Projects
Log inSign up
Stesso

Step 5 · Test Fit Balusters

Before permanent installation, place each cut baluster in its intended position without adhesive or fasteners. Check that the top of the baluster sits flush against the underside of the handrail and the bottom rests securely on the tread or riser. Ensure there are no gaps and that the baluster is plumb (if applicable) and stable. Make any necessary minor adjustments by slightly trimming an angle or length if a baluster is slightly off. This step is crucial to avoid costly mistakes during final installation.

Stesso home
SearchSearchBrowseBrowseFeedFeedMy ProjectsMy Projects
Log inLog inSign upSign up

Step 5 · Test Fit Balusters

Before permanent installation, place each cut baluster in its intended position without adhesive or fasteners. Check that the top of the baluster sits flush against the underside of the handrail and the bottom rests securely on the tread or riser. Ensure there are no gaps and that the baluster is plumb (if applicable) and stable. Make any necessary minor adjustments by slightly trimming an angle or length if a baluster is slightly off. This step is crucial to avoid costly mistakes during final installation.

Videos for this step

Measure and Mark Baluster Length

Tools and Materials

← Project

How to Measure and Cut Stair Balusters to the Right Angle

Step 5 of 5·30 min left

Measure Angle of Stair Slope
15 minutes5 items
Determine Baluster Length
20 minutes4 items
Set Up Saw for Angled Cuts
15 minutes4 items
Cut Balusters to Length
60 minutes7 items
5
Test Fit Balusters
30 minutes2 items
PrevNext
TermsPrivacySafetyLegal© 2026 Stesso, Inc.