After you believe the clog has been cleared, you must test the system. Have your helper go inside and flush the toilets and turn on the faucets in the sinks and tubs that were previously draining slowly. They should report back whether the gurgling has stopped and if the water is draining quickly and smoothly. For a final confirmation, you can use the garden hose to run water down the vent stack for a minute or two to ensure it flows freely without backing up. Once confirmed, replace the vent cap if there was one, clean up your tools, and carefully make your way off the roof.
Step 1
⏱ 2 min
Prepare for Roof Safety
Before any work begins, your absolute priority is safety. Check the weather forecast to ensure a clear, dry, and calm day. Position a sturdy extension ladder on firm, level ground, extending it at least 3 feet above the roofline for safe access. Ask a helper to act as a spotter to hold the ladder steady. Wear appropriate safety gear, including heavy-duty work gloves to protect your hands and sturdy, non-slip, soft-soled shoes or boots for maximum grip on the roof surface. If your roof has any significant pitch, a safety harness anchored to a secure point is strongly recommended.
Step 2
⏱ 2 min
Locate the Vent Stack
Carefully climb the ladder and step onto the roof. Move slowly and deliberately. Locate the plumbing vent stack, which is a vertical pipe protruding from the roof. It is typically made of PVC (white plastic) or cast iron (black metal) and is usually 1.5 to 4 inches in diameter. Vents are often positioned directly above a bathroom or kitchen area. There may be more than one vent stack on your roof.
Step 3
⏱ 2 min
Inspect and Clear Surface Debris
Once at the vent stack, perform an initial inspection. If there is a cap, it may need to be twisted or pried off. Look down into the pipe opening, using a flashlight if necessary to see deeper. Often, the clog is near the top. Wearing your work gloves, manually remove any visible debris like leaves, twigs, animal nests, or other foreign objects. Be cautious, as there could be insects or startled animals inside.
Step 4
⏱ 2 min
Flush with Garden Hose
For clogs deeper in the pipe, a garden hose can be effective. Have your helper on the ground connect a garden hose to a spigot and bring the other end up to you on the roof. Attach a spray nozzle set to a 'jet' or high-pressure stream. Insert the hose a few feet into the vent stack. Signal your helper to turn the water on at full pressure for 15-20 second bursts. The force of the water can often dislodge and flush down common clogs. Have a third person inside (or your helper) listen for the gurgling sounds to stop and for water to flow freely down the pipe.
Step 5
⏱ 2 min
Use Drain Auger for Stubborn Clogs
If the garden hose fails to clear the blockage, the next step is to use a drain auger, also known as a plumber's snake. Insert the tip of the auger into the vent stack and begin feeding it down the pipe. Continue pushing until you feel resistance, which indicates you've reached the clog. Once you hit it, lock the auger cable and turn the handle clockwise. This motion will either break the clog into smaller pieces or allow the auger's corkscrew tip to hook onto the debris so you can pull it out. Work the auger back and forth to thoroughly clear the obstruction. Be careful not to be overly aggressive, which could damage the pipe, especially if it is older PVC.
Step 6
⏱ 2 minTest the Plumbing System
Step 6/6
Test the Plumbing System2 min