Skip to main content
Stesso

Prepare Equipment and Whitewash Mixture

0:08
1:01
58.5K views

At 0:08 in

White washing old brick #fyb #shorts #diy

Watch on YouTube

What happens here

Begin by setting up your Dyno X6 airless sprayer. The presenter recommends using a 311 HCA tip and operating the sprayer at a very low pressure, specifically around 400 PSI. This low-pressure setting is crucial for minimizing overspray and reducing the amount of paint dust in the air, especially important in hot conditions (over 100 degrees Fahrenheit as mentioned). Next, prepare your whitewash mixture by combining Montage Signature paint with water in a two-to-one ratio (two parts paint to one part water). Ensure the mixture is thoroughly stirred to achieve a consistent, thin consistency suitable for spraying and a translucent finish.

Goal: Set up the airless sprayer and prepare the diluted paint for whitewashing.

Tools and materials

  • 311 HCA Tip — Controlling the spray pattern and reducing overspray
  • Dyno X6 Airless Sprayer Dyno — Applying the diluted paint to the brick surface
  • Face Mask — Protecting respiratory system from airborne paint particles
  • Gloves — Protecting hands from paint
  • Mixing Container — Diluting the paint with water
  • Safety Glasses — Protecting eyes from paint spray
  • Stir Stick — Thoroughly mixing the paint and water
  • Water Tap water — To dilute the paint for a whitewash effect

What they say

Hide

So to then out here, whitewashing some brick, using a Dino X6 airless sprayer, using a really low pressure, like about 400 psi with a 311 H8 tip, so I don't have a whole lot of over spray, a lot of dust in the air, it's over 100 degrees, a miserable wear and a mass one, cutting down an over spray and dust in the air by running low pressures, just using

Auto-generated from the video audio.