Apply Epoxy and Reattach Letter

3:09

5:39

36.9K views

At 3:09 in

What is J-B Weld for? How To Repair With J-B Weld

Watch on YouTube

What happens here

Once the JB Weld is thoroughly mixed, apply a small dab of the dark gray epoxy mixture to the back of the metal letter that needs to be reattached. The host carefully applies it to the existing plastic fittings on the back of the letter. Avoid applying too much, as excess can squeeze out and create a mess. Carefully position the letter back onto its original spot on the sign, pressing it firmly but gently into place. Ensure it is aligned correctly. Wipe any immediate excess epoxy off the mixing stick. Let the repaired letter set without disturbing it for the recommended 4-6 hours before handling, and allow 15-24 hours for a full cure.

Goal: Securely reattach the metal letter to the sign.

Tools and materials

Mixing Stick — Applying the mixed epoxy to the letter
Sign with Detached Letter — The surface where the letter will be reattached
Metal Letter — The item being reattached
Mixed JB Weld Epoxy JB Weld — To bond the metal letter to the sign

What they say

(847 characters)

Hide

they can withstand temperatures up to 550 degrees so you can actually i've i didn't glue some parts on my boat engine with it but somebody else did and they actually held up and stuck so there's all mixed up dark gray now i'm just going to apply a little bit to each one of these um plastic fittings right here they're those were plastic this has an epoxy on here that's um failed so the sign guy that made this didn't use too strong of an epoxy the epoxy obviously stuck to the metal i'm good enough but not to the to the plastic fitting so i'm just going to dab a little bit on there i don't need a whole lot i'm going to wipe it off it's not water based so you don't you can't clean up with water so i'm just going to take my e i'm going to fit this thing back on there it's fixed educate empower and equip is all repaired so i'm gonna let that

Auto-generated from the video audio.